Strip light connectors12/3/2023 ![]() Failure to lock the connector tightly will cause insufficient contact between the conductor and the light strip pad, resulting in spark strike arc, which will generate heat and cause the connector to overheat. This problem can also cause serious heating of the connector. If the length required by the project causes excessive total current, it is recommended that you connect and install the light strip in the way shown in the figure below. The solution is to determine the maximum current of the connector before use, calculate how much current will be generated by the light strip to be connected, and then determine how many connectors are needed to connect the light strip. If the current of the light strip exceeds the limit of the connector when connecting the light strip, it will cause the connector to overheat. Usually, the connector has a maximum current limit. Overheating usually comes from the following reasons When crimping the terminal to the wire rod with the machine, it is not checked whether it is reliable. This is a problem of production quality control. ![]() The terminal and wire rod are not done well strip light doesn’t face to the correct side ![]() If the front and back sides are mistaken, the best contact and fixing force will not be obtained. Some pierced connectors require the connector to be pierced from the back of the circuit board and fixed from the front. Or when using the pierced light strip connector, the light strip is not placed above the needle, but close to the front of the needle. The light strip is not in the correct positionįor example, when inserting the light strip, its insertion depth is not adjusted so that the hardware is placed above the pad. For some pierced-to-contact light strip connectors, pulling the light strip will cause the pierced hole to become larger and the connector cannot connect to the circuit. Poor contactįor some surface contact connectors, this will cause the conductor to not fall in the correct position of the pad, which will affect the current connection. The article will tell you why they happen and how to fix or avoid them. However, there will also be some problems in the actual application, which usually appear as follows: It is common knowledge that using connectors to connect LED light strips can improve connection efficiency and save installation time and labor cost.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |